1.Storage（儲存）

☆Moisture proof and anti-electrostatic package with moisture absorbent material is used,to keep moisture to a minimum.Before opening the package, the product should be kept at 30℃ or less and humidity less than 60%RH,and be used whthin six months.
本產品使用密封防潮搞靜電袋包裝，并附有干燥劑，以保證產品不會吸潮,產品包裝在開封前，產品須放在溫度不高于30℃,濕度不高于60%RH的環境中。
☆After opening the package,the product should be stored at 30℃or less and humidity less than 10%RH,and be soldered within 24 hours.It is recommended that the product be operated at the workshop condition of 30℃or less and humidity less than 60%RH.
產品包裝開封后，產品必須儲存在溫度不高于30℃，濕度不高于10%RH的環境中，且應該在24小時內使用完，建議工作環境為溫度不高于30℃，濕度不高于60%RH。
☆If the moisture absorbent material has fade away or the LEDs have exceeded the storage time,baking treatment should be performed based on the following condition(75±5) ℃ for 24 hour.
對于尚未焊接的ＬＥＤ，如果吸濕材料或包裝失效，或者產品沒有符合以上有效儲存條件，烘烤可以起到一定的性能恢復效果，烘烤條件：75±5 ℃,持續24小時。

2.Static electricity（靜電防護）
☆Static electricity or surge voltage damages the LEDs.Damaged LEDs will show some unusual characteristic such as the forward voltage gecomes lower,or the LEDs do not light at the low current.even not light.All devices,equipment and machinery must be properly grounded.At the same time,it is recommended that wrist bands or anti-electrostatic gloves,anti-electrostatic containers be used when dealing with the LEDs.
靜電或電涌會導致產品特性發生改變，例如正向電壓降低，如果情況嚴重甚至會損毀產品，所以在使用時必須采取有效的防靜電措施；所有相關的設備和機器都應該正確接地，同時必須采取其他防止靜電和電涌的措施，使用靜電手環，防靜電墊子，防靜電工作服，工作鞋，手套，防靜電容器，都是有效的防止靜電和電涌的措施。